Home > Test & Measurement > Telecom/Datacom Testers
Sort By:
Page of 1
Ideal Industries 62-140 Byte Brothers Inc CTX200 Byte Brothers Inc CTX590A
TraceTone Tester; 62-140
Our Price: $54.42
The 62-140 is a Tone Generator & Amplifier Probe with 2 selectable tones. Cable assembly included. Get instant verification of your CAT5/6 network cables with the handheld Pocket Cat tester. It performs complete TIA568 tests on every wire pair, identifying continuity, opens, shorts, reversals and splits. It's ruggedized for field use (no LCD to break) and the included remote stores in a hidden drawer. Includes CAT6 patch cable, coax terminator, belt clip, 9V battery and zippered pouch. The ProTone wire locator includes a tone generator that can connect to network, phone and other cables, and a tracer that detects and identifies both the generated signals and 60Hz AC waveforms as well. Use them together to identify specific wires in bundles or cable runs, or to determine whether a power line is hot or not without contacting it. Thanks to attached alligator clips, the tone generator can be used for all wire types, but it has plugs for specifically testing telephone and network lines too. Includes case and 9V battery.
b+k 231a Amprobe LAN-1 Byte Brothers Inc RWC1000K
The 231A can easily read the correct pin configuration of 10BaseT cable (category 5), 100BaseTx, 10Base2 cable (coax) and RJ45/RJ11 modular cables, 356A, TIA 568A, TIA 568B and Token Ring cables by comparing one transmitting end to the corresponding receiving end. With the remote kit, it can test cables installed far away either on wall plate or patch panel up to 1000ft away. It is easy to verify the cable continuity, open, short, and cross connect, featuring auto or manual scan for pin-out indicators.

   Tests 10BaseT, 100BaseTx, 10Base2, RJ45, RJ11, 356A, TIA 568A, TIA 568B, and Token Ring cables
   Detects open, short, cross, and continuity
   Tests Point to Point, rather than Pair to Pair
   Quick and easy to use
   Tests cables on wall plate or patch panel up to 1000 ft away with the remote kit
   Easy to read LED display
The Amprobe LAN-1 Cable Tester is designed for testing opens, shorts and miswired cable installations. It is designed to work with various data cables and connectors. This cable tester provides a quick go/no-go LED display of the wiring and connection of item under test. You can either step through the test cable wiring one at a time or have the unit automatically pulse through the pin-outs and display the results. Certify and troubleshoot your LAN hardware, 10/100 and Gigabit cabling with one device! The Certifier takes network testing to a whole new level by not only offering standard wiring tests, but by also offering both device and cable performance. This world-class certifier/tester spots slow cables, bad connectors, incorrect wiring, noisy cable, improper lengths and low signal levels from hubs, switches and PCs, decodes hub, switch, and PC speed capabilities, and tests the negotiation speed between two devices.