|
|
|
|
|
|
|
|
|
|
|
|
|
|
Apart from giving a high quality appearance, ferrules also ensure the reliability of the connection and installation.
|
Non-insulated wire ferrule. 20-22 AWG
|
Non-insulated wire ferrule.
16 AWG (1.50mm²) X 10mm LONG
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Non-insulated wire ferrule. 12 AWG
|
|
Non-insulated wire ferrule. 10 AWG
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Non-insulated wire ferrule. 14 AWG
|
ORANGE INSULATED WIRE FERRULE
20 AWG (0.50mm²) X 8mm LONG
|
Insulated wire ferrule, 20-22 AWG White
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Non-insulated wire ferrule. 10 AWG
|
Insulated wire ferrule, 18 AWG Yellow
|
W Type Twin-Wire Ferrule for Two Wires
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
W Type Twin-Wire Ferrule for Two Wires
|
W Type Twin-Wire Ferrule for Two Wires
|
Insulated wire ferrule, 14 AWG Blue
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Insulated wire ferrule, 16 AWG Red
|
GRAY INSULATED TWIN WIRE FERRULE for Two 20 AWG(0.50mm²) Wires
8mm LONG
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Insulated wire ferrule, 12 AWG gray
|
|
Terminal Blocks are manufactured with one open end allowing side by side placement. An end plate is necessary for the last terminal block in the assembly enabling full enclosure.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
LOCKNUT PG 7 NYLON GRAY
|
LOCKNUT PG 11 NYLON GRAY
|
Terminal Blocks are manufactured with one open end allowing side by side placement. An end plate is necessary for the last terminal block in the assembly enabling full enclosure.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
LOCKNUT PG 13 NYLON GRAY
|
2 Poles, 5.08 mm Pitch, Single Level, Printed Circuit Board Terminal Block
|
To prevent terminal blocks from falling of the DIN Rail, they must be secured on each side. This is accomplished with end brackets screwed onto the rail. Two end brackets are necessary - one on each side of the continuous assembly designed.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
LOCKNUT PG 9 NYLON GRAY
|
DIN Rail Terminal Block. Width: 5 mm. Feed-Through Terminals
|
To prevent terminal blocks from falling of the DIN Rail, they must be secured on each side. This is accomplished with end brackets screwed onto the rail. Two end brackets are necessary - one on each side of the continuous assembly designed.
|
|
|
